Roche Accu-Chek Active Manual do Utilizador descarregar pdf (Página 18)

Each time you open a new pack of test strips, you will need

to insert the coding chip that came with that pack into your

monitor. Coding chips from other packs contain the wrong

information for your new strips, so test results will be incorrect.

Leave the coding chip in the monitor until you have used up all

of the test strips from a particular pack.

Check that the three-digit code (e.g.

133

) printed on the chip

matches the code printed on the label of the container the test strips

came in. When coding is complete, your Accu-Chek Active monitor

will display the code number.

The properties of the Accu-Chek Active test strips you use with the

monitor may differ very slightly from one pack to another (because

of lot-to-lot differences). Your Accu-Chek Active monitor must be

programmed to allow for these differences in properties in a process

known as “coding”. All the information relating to the strips in a

particular pack of Accu-Chek Active test strips is held in the coding

chip that comes with that pack.

3.3 Coding

015134 AccuChek Active_Eng.indd 32-33 12.08.2004, 14:54:13

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 70 71

Sem comentários

Roche Accu-Chek Active Manual do Utilizador Página 18