Roche CoaguChek XS System Manual do Utilizador descarregar pdf (Página 63)

Testing a capillary blood sample

15 The test strip symbol prompts you

to insert a test strip. Remove a test

strip from its container and close the

container again with the stopper.

16 Hold the test strip so the lettering

“CoaguChek XS PT” is facing upward.

17 Slide the test strip into the test strip

guide in the direction indicated by the

arrows.

Slide the test strip in as far as it will

go. A beep tone indicates that the

meter has detected the test strip

(provided the beeper is turned on in

the settings).

Test

09:15 am

09/16/2009

184

P-ID: PID01

Smith, Henry

Op: Operator 1

Par: PT

Please note: Exposure to external influences (such as humidity) may deteriorate the

test strips and lead to error messages. Therefore, always close the container with the

stopper in place immediately after removing a test strip.

If you use a new test strip lot and have

not inserted the code chip yet, you must

do so now. Otherwise you cannot perform

a test. Depending on the setting, you may

also be required to run a liquid quality

control at this point.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 107 108

Sem comentários

Roche CoaguChek XS System Manual do Utilizador Página 63