Roche ACCU-CHEK Inform II Manual do Operador descarregar pdf (Página 127)

Maintenance and Care

127

Disinfecting the base unit

■ Remove the meter from the base unit prior to

disinfecting.

■ Unplug the base unit before disinfecting.

■ Be certain that solutions contain acceptable active

ingredients for disinfecting the system. If using

commercially available pre-moistened disinfecting

cloths, squeeze off excess disinfecting solution

or blot on a dry paper towel to remove any excess

disinfecting solution.

■ Wipe the base unit thoroughly. Do not wipe over the

cable connector areas in the rear of the base unit.

If solution enters any of these areas, dry them off

immediately using a soft, dry cloth.

■ Allow the base unit to air dry for the recommended

contact time according to the disinfecting solution

product labeling. Do not place the meter in the base

unit until all disinfecting steps are completed.

■ Dry the base unit thoroughly with a dry cloth or

gauze and visually verify that no solution is seen in

the connector and cable areas at the completion of

disinfecting. Ensure that the base unit

(including connectors) is thoroughly dried

after disinfecting.

■ Plug in the base unit.

NOTICE

Do not allow liquid to enter the connectors. If liquid does

get into the connectors, immediately dry the components

with a dry cloth or gauze. If solution is allowed to col-

lect in any base unit connector, severe damage can

occur.

NOTICE

Do not spray the base unit directly with solutions as this

could cause the solution to enter the case and damage

the electronic components.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 159 160

Sem comentários

Roche ACCU-CHEK Inform II Manual do Operador Página 127