Roche ACCU-CHEK Inform II Manual do Operador descarregar pdf (Página 52)

Glucose Control Testing

Glucose control testing intervals

Intervals between running glucose control tests are

determined by your facility. These intervals are entered

when the system is congured. At the end of the speci ed

interval (or after a specic event such as starting to test

with a new test strip lot), a warning is displayed when the

meter is switched on and when the Glucose Test function

is selected.

Glucose control tests should be run in the following

cir cumstances:

n Before using the meter for patient testing the rst

time

n At the glucose control intervals established by your

facility, if established

n When using a new test strip vial for the rst time

n When using a new test strip lot for the rst time

(and as a result a new test strip code)

n If a test strip vial was left open

n If questionable test results are displayed repeatedly

n If you wish to test the performance of the system

In addition, the following events can be specied during

setup as a reason for a glucose control test:

n If a previous control test is out of range

n If glucose control tests were not run at the proper

intervals

If a glucose control test is required (as shown in the

illus tration on the left), you will not be able to test blood

glu cose until the controls have been run successfully. For

emergencies, STAT tests can be congured in the meter.

This option allows the meter to perform a limited number

of blood glucose tests, if circumstances require, despite

the meter being in QC Lockout (see page 61).

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 191 192

Sem comentários

Roche ACCU-CHEK Inform II Manual do Operador Página 52